A SERVICE OF

logo

Open as PDF
next previous
25Printer-Applicator-System PAM 3000
6 Connecting the Printer
Air Connection
Fig. 6a Air connection
PAM 3000 needs for operation the connection to a compressed air supply. It is very important
to guarantee an operating pressure of 5 bar with a tolerance of plus/minus 5 % .
The air connector (1) is located at the side of the printer. The push-in-fitting is suitable for a
8mm-tube.
CAUTION !
Make sure that the compressed air supply is switched off while connecting the
printer.
Insert the tube of compressed air supply into the push-in-fitting (1). Insert the tube firmly.
Adjust the required operating pressure.
1
CAUTION !
Use only filtered compressed air to operate the printer.
Guarantee an operating pressure of constant 5 bar during operation.