Filter
Top Products
11
To Set: Action: Display: Action: To Finish: Notes
Programming
Waking
Awaken to the nature sound, radio station and/or light intensity you have programmed.
Alarm Time
Press and
Hold WAKE
Flashing 12:00
(or the last
time you have
set) and
or
to desired
wake time
(Hold
button to
accelerate
display.)
Press OFF/
SET. Your
setting will
be stored.
After eight
seconds of
inactivity,
the unit will
store what
has been
programmed
and return to
the normal
time display.
This step does not
activate the alarm;
it only sets the alarm
time. To activate the
alarm, see "Turning the
Alarm Program On &
Off" later in this section.
Light
Duration and
Type
Press and
hold WAKE.
Press WAKE
again.
Flashing
or for
illumination
type and
duration
(See Key
#1, page 10
or 13.)
Maximum
Light
Intensity
NOTE: If
you set the
light type
to “OFF” in
the previous
step, the
programming
will
automatically
skip this step
and initiate
the “Wake-up
Sound” step
below.
Press and
hold WAKE.
Press WAKE
twice more.
Initial or
previous light
setting and
or for
maximum
desired light
intensity.
(Choose
between
LL1, LL2
and LL3.)
Wake-up
Sound
NOTE: If
you select
radio rd in
this step, an
additional
step will
allow you to
select your
radio station.
Use the
or
to do so.
Press and
hold WAKE.
Press WAKE
three times
more.
Initial or
previous
sound setting
and
or
, depending
on what is
currently
programmed
or
to choose
sound (See
Key #2,
page 10 or
13.)
The wake-up/alarm
sound you play and the
light (if you've activated
it) will stay on for 60
minutes or until you
turn them off, whichever
occurs sooner.
Volume of
Wake-up
Sound
Press and
hold WAKE.
Press WAKE
four times
more.
, and
previous
sound-level
setting
or to
choose L1,
L2 or L3.
Five minutes before
the set alarm time, the
wake-up sound will
begin at a low volume
and get progressively
louder until, at alarm
time, it reaches the
maximum volume you
have set.
Programming the Rise & Shine — continued