Filter
Top Products
46
operator in the first ten phone list entries. These numbers are accessed by pressing p then
following the selection mode rules.
The following steps are required to dial these numbers:
1. Follow the procedure in Sending a Telephone Interconnect Call (Trunked Mode Only) to
establish a connection to the telephone system or consult the system administrator for the
procedure to access a dial tone on the trunked or conventional system.
2. Overdial numbers are transmitted using either method as follows:
METHOD 1:
Press and hold PTT while entering the overdial number sequence from the
keypad. This method sends DTMF tones during individual, telephone
interconnect, trunked group, or conventional channel calls. Anytime the PTT
button is pressed and held, the keypad is enabled for DTMF entry.
METHOD 2:
Press p to enter the overdial select/entry mode and follow the selection mode
rules to call up a stored number from the phone list or to directly enter the
overdial digits. Press PTT to send the overdial sequence once. If the number needs
to be transmitted again it must be selected or entered again (this prevents
unwanted numbers from being sent the next time the PTT button is pressed during
the call).
This overdial select/entry mode remains active until the call is dropped, cleared, or m is
pressed. The overdial select/entry mode can be re-entered if the call is still active by pressing
p.
12.9.4 Programmable Entries
Individual call ID numbers, telephone numbers and other number sequences for overdialing are
stored in the special call lists when programming the radio. The first ten entry locations of these
lists can be changed by the radio operator. The keypad is used when adding, changing and storing
numbers in these entry locations.
Use the following procedure to store a number in one of the first ten entries of a special call list:
1. Press i or p to enter the individual call list or the phone call list. The selection mode
rules apply.
2. Scroll through the list using the RAMP controls, , or ., until one of the first ten entries
is reached. NO ENTRY is displayed if the location is empty.
3. Enter the desired number. If necessary, a pause can be entered by pressing and holding 0-9,
(*), or (#) until an underscore appears in the display. The individual call list entries will
accept up to 5 digits. The phone call list entries accept a combination of up to 31 digits and
pauses.
4. Press and hold m until the display changes indicating that the number has been stored.
5. Repeat the steps above if the number stored in an entry location needs to be changed.
12.10 MOBILE DATA
The M7100
IP
Series mobile radios, when operating in the EDACS configuration, permit either voice or
data calls to be transmitted or received. The radio can handle only one type of call at a time; however,
selection of either data or voice is selected transparently by the operator through normal usage of the radio.
Data communications is not supported in the conventional mode.