Filter
Top Products
user manual
TCS series
tcs manual
page 25
Rigging Instructions for a 3-wide TCS-56/59 array
Parts required: 3 x TCS-56 or TCS-59 enclosures
1 x TP-55/3 flying assembly top plate
1 x BP-55/3 flying assembly bottom plate
4 x M10 x 36mm shoulder eyebolts
8 x M10 x 36mm hex head bolts
12 x flat washers
12 x spring washers
1. Set the cabinets out on the floor with the approximate desired horizontal splay angle.
2. Remove the countersunk screws from the rigging points on the top of the cabinets.
3. Set the TP-55/3 flying assembly top plates (two are required per array) on the
cabinets, aligning the slots with the enclosure rigging points.
4. Assemble the top plates to the cabinets using M10 x 36mm eyebolts and M10 x
36mm hex head bolts as shown.
5. Set the cabinets to the desired horizontal angle using the marked positions on the top
plate. As a starting point this will generally be 0
° between cabinets (tight packed) in
the case of the TCS-56, and 30
° in the case of the TCS-59.
6. Invert the array and attach the BP-55/3 bottom plate to the bottom of the cabinets by
removing the countersunk screws and replacing them with M10 x 36mm hex head
bolts.
7. Make final adjustments to the angle between
cabinets in order to achieve the best coverage
from the array. Tighten all hardware and
prepare to lift the array into position.
8. Downward inclination of the completed array
can be set using the eyebolts attached to the
rear rigging points on the two outside TCS-
56/59 cabinets.
9. Attach safety chains to the holes provided at
the rear of the flying assembly top plates.