Filter
Top Products
user manual
TCS series
tcs manual
page 21
Installation of a single TCS series enclosure using WB-10, WB-20, W-55, CB-10, CB-55
wall and ceiling brackets
Parts required: Turbosound wall or ceiling brackets as appropriate
4 x M10 x 36mm hex head bolts
4 x flat washers
4 x spring washers
1. Ensure you have the correct Turbosound bracket for the intended application and
weight of the enclosure. Verify the net weight of TCS series enclosure to be installed
from the technical specifications section at the end of this manual.
2. Remove the captive countersunk bolts from the rear of the cabinet using a flat blade
screwdriver.
3. Attach the Turbosound bracket using the hardware provided. Apply a suitable thread
locking compound such as Loctite 222 (see Appendix C), and tighten as necessary.
Installation of a single TCS series enclosure using SB-30 and SB-40 swivel brackets
Parts required: Turbosound swivel brackets as appropriate
2 x M10 x 36mm hex head bolts
2 x flat washers
2 x spring washers
2 x No.6 x 1” woodscrews
1. Remove the captive countersunk bolts from the top of the cabinet using a flat blade
screwdriver.
2. Assemble the swivel bracket to the enclosure using the spring washers and flat
washers as stand-offs. Apply a suitable thread locking compound such as Loctite 222
(see Appendix A), and tighten as necessary.
3. Adjust the cabinet angle as necessary and lock by inserting the No.6 woodscews
through the swivel bracket into the side of the cabinet.