Filter
Top Products
user manual
TCS Compact series
tcs compact manual
page 32
Removal of the HF compression driver and LF driver
The perforated steel loudspeaker grille (1) is held in place under tension only, fitting into
slots at either side of the baffle. There are no screws or other fixings holding the grille in
place. Lay the cabinet on its back and, using two small screwdrivers inserted through the
mesh of the grille, firmly pull the grille away from the slot at one side of the baffle until it
is free. Set the grille aside for later re-assembly.
Undo the screws (2) holding the driver (5) in place and carefully lift it out and away from
the cabinet. Make a note of the driver polarity for later reconnection. Disconnect the
cables from the drive unit and completely remove the driver from the cabinet being
careful not to damage the cone or suspension. Do not place the driver near to any
equipment or media that may be adversely affected by strong magnetism, e.g. CRT
monitors or magnetic tape of any kind.
Remove the horn/driver (4) assembly by unscrewing the four screws (3) holding the
flange in place. Lift it out and away from the cabinet. The high frequency driver can now
be disassembled from the HF horn.
To reinstate the driver(s) simply reverse the above procedure, making sure you observe
the correct polarity when reconnecting the cables back into the terminals of the drive
units.