Filter
Top Products
user manual
TCS Compact series
tcs compact manual
page 28
Flying Single Enclosures
Single enclosures may be flown using a variety of different methods:
All TCS COMPACT series cabinets, including low frequency enclosures, can be rigged in
permanent installations using optional M10 shoulder eyebolts (available from
Turbosound or third party suppliers). These can be attached to the rigging points
provided on the top and back of the cabinet. The rigging point at the rear of the cabinet is
used to alter the downward angle of the enclosure.
As supplied, these rigging points are fitted externally with M10 countersunk slot-head
screws. To facilitate rigging of the enclosure simply remove these M10 screws and
replace them with M10 x 18mm shoulder eyebolts using a suitable thread locking
compound to avoid the possibility of loosening.
Note: Eyebolts must have a thread length of at least 18mm (3/4”).
NOTE: The rigging points are designed to suspend single enclosures only. There is no
facility to hang an additional cabinet below a flown TCS COMPACT series enclosure.
WB-55
wall bracket
CB-55 ceiling bracket
SB-101 swivel bracket
(TCS-101C only)
M10 eyebolts