Filter
Top Products
Troubleshooting
Troubleshooting
If a problem occurs with your MP630, please first check the information listed below before taking your
MP630 for repair. If you are unable to remedy a problem from the following hints, please consult your
dealer, service center, or local Transcend branch office. We also have FAQ and Support services on our
websites.
Software CD cannot auto-run in Windows
®
Go to the Device Manager in the Control Panel and enable the Auto-Insert function for the CD-ROM
drive. Alternatively, you can manually run the “MP630.EXE” file on the software CD.
Operating system cannot detect the MP630
Check the following:
1. Is your MP630 properly connected to the USB port? If not, unplug it and plug it in again.
2. Is your MP630 connected to the Mac keyboard? If yes, unplug it and plug it into an available USB port
on your Mac Desktop.
3. Is the USB port enabled? If not, refer to the user’s manual of your computer (or motherboard) to
enable it.
Cannot Power ON
Check the following:
1. Is the MP630 connected to your computer? If yes, unplug it.
2. Is the LOCK switch set to “LOCK”? If yes, set it to the “OFF” position.
3. Is the battery out of power? If yes, please recharge the battery.
Cannot download MP3, WMA, WMA-DRM10, or WAV files to the MP630
As required, uninstall and re-install the driver. If this doesn’t work, try Resetting the unit and if this fails,
please see the “Restoring Factory Defaults” section to recover your MP630.
Buttons aren’t working
Is the LOCK switch set to “LOCK”? If yes, set it to the “OFF” position.
52