Filter
Top Products
24
Preparations
Preparation of the remote control
Insert the specifi ed battery to the remote control. See
page
8
,
9
for safety use of coin-shaped batteries.
1
Gently insert a fi ngernail in groove
q
and pull out the holder in direction
w
.
Take care not to break your fi ngernail.
2
Place a coin-shaped
battery (CR2025) with the
side up on the holder.
Keep the holder horizontal so that
the battery does not fall through.
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the same or
equivalent type.
3
Insert the holder into the remote control.
The remote control battery contains Perchlorate
Material - special handling may apply.
http://en.wikipedia.org/wiki/perchlorate
Operating with the remote control
Point the remote control at the remote sensor and press
the buttons.
Distance: About 3 m (9.9 feet) from the front of the remote
sensor
Angle: About 30° in each direction of the front of the
remote sensor
Do not expose the remote sensor of the player to a strong light
source such as direct sunlight or other illumination. If you do
so, you may not be able to operate the player via the remote
control.
Aim the remote control at the remote sensor of the player.
Do not drop or give the remote control a shock.
Do not leave the remote control near an extremely hot or humid place.
Do not spill water or put anything wet on the remote control.
Do not disassemble the remote control.
If the remote control does not function correctly or if the operating
range becomes reduced, replace the battery with new one.
Inserting a battery other than the specifi ed one or an object may
damage the remote control.
2#
6
Backside
1
2
Within about 3 m (9.9 feet)
SD-P1900SR_P1-52.indd 24 07.3.8 8:30:40 PM