Filter
Top Products
7
Guide To Features (Rear Panel)
1. CONNECTING CABLE: Connect the male RCA from this cable to the Model Three
clock radio’s rear female RCA output marked “R-SPR” and switch to Stereo. Set
the Model Three’s rear Balance Control to the center detent position for equal balance
between the two speakers. Connecting a speaker other than the Tivoli Audio Dual
Alarm or Stereo Speaker will void your warranty and possibly damage your unit.
2. 12VDC, 10mA: Connect the included AC power supply to this input. Use only the
power supply provided with this product. To obtain a replacement,
contact your authorized dealer or Tivoli Audio, USA: 1.877.297.9479.
The power supply connector is 5.5mm/2.1mm x 13mm long, center
positive. Do not connect the power supply to an electrical outlet
controlled by a wall switch. It is normal for the power supply to become warm during
use. An optional 12VDC nominal, 1.5A fused source may also be used.
3. TIME SET: Briefly press and release this button to advance the hands in small
increments. Press and hold this button to continuously advance the clock’s hands.
Release the button when the clock is set properly. Be sure the alarm button is in
the Off position when setting the time. See “How to set the clock”.
4. ALARM GRILLE: The alarm beep emits from this grille. Do not block this grille.
5. BATTERY BACK UP: Remove the battery cover and install a fresh major brand 1.5V
“AA” battery, observing correct +/– polarity. The clock operates off of
the battery continuously and the battery also acts as a back up. In the
event of a power failure, the battery back up will maintain the clock’s
operation and sound the wake-up tone if the alarm button is in the On
position, provided a fresh battery is correctly installed. The clock face will not illuminate
and the radio will not operate during a power failure in order to conserve battery
life. Check the battery’s strength annually and replace only with a major brand,
1.5V “AA” alkaline battery. If the clock stops operating, replace the battery. To
reduce the risk of fire or injury, do not leave a dead battery in the clock. Do not
dispose of the spent battery into a fire. Do not open or tamper with the battery. Do
not recharge the supplied battery. Dispose of the spent battery according to your
state/country's regulations. Remove the battery if the Dual Alarm is to be stored or
unused for a long period of time.