Filter
Top Products
NOTE: You must make the time and alarm time adjustments while the display is flashing. If no adjustments are made for approximately
8 seconds the display will stop flashing and cannot be adjusted. If this occurs you must start the time and alarm setting procedure again
and make sure that you complete the adjustments while the display is flashing.
Radio Operation
POWER/MODE/ALM RESET Button – When the unit is ‘off’, pressing this button will cycle through available modes: FM Radio > AM
Radio > AUX > BT to select the following operating modes:
First Press – FM Radio band. The initial default display is 87.5 mHz.
Second Press – AM Radio band. The initial default display is 520 kHz.
Third Press – AUX (AUH) mode. To listen to an external audio source.
Fourth Press – Bluetooth Mode.
1. Press the POWER/MODE/ALM RESET button to turn the radio ‘on’ and select the FM band. The initial FM frequency display is 87.5
mHz. Press the POWER/MODE/ALM RESET button again to select the AM band. The initial AM frequency display is 520 kHz.
2. After selecting the desired band tune to a radio station by either the automatic or manual tuning method:
• Automatic Tuning – Press and hold the HOUR / or MIN / button until the frequency display begins to move, then release the
button. The tuner will search up or down for the next strong station and stop on that station. Repeat this procedure until the tuner
stops on the desired station. After a few seconds the display will change from the radio frequency back to the correct time.
• Manual Tuning – Repeatedly press the HOUR / or MIN / button until the display shows the frequency of your desired station. Use
the Manual Tuning method to tune to weaker stations that could be bypassed during automatic tuning. After a few seconds the
display will change from the radio frequency back to the correct time.
3. Press the ALM 1 (VOL +) or ALM 2 (VOL -) button to adjust the radio volume level. The display changes to show the volume level
indication (00 to 20) during volume adjustments, then changes back to the radio station frequency, and then the current time.
4. When you are finished listening press and hold the POWER/MODE/ALM RESET button until the display shows OFF, then release the
button. The display will then return to the correct time.
Last Station Memory
The tuner remembers the last FM and AM stations that you were listening to and automatically returns to those stations the next time
you select the FM or AM mode.
Preset Station Memory
The tuner can store up to 10 FM and 10 AM station in memory for easy recall. To store a station in memory:
1. Tune to the first station that you wish to store using either the Automatic or Manual Tuning methods described above.
2. When the display is showing the frequency of the desired station, press and hold the CLOCK / PRESET / PAIR button until the “P
01” indicator begins flashing in the display.
3. Press the CLOCK / PRESET / PAIR button once more to store your station in Preset Memory number 1. The preset indicator will
automatically advance to “P 02”.
4. Repeat steps 1 thru 3 until you have stored up to 10 stations of one band, then change bands and follow the same procedure to
store up to 10 stations of the remaining band.
5
Operating Instructions