Filter
Top Products
5
Nap Timer
The Nap Timer allows you to set a 3rd alarm to wake you after a nap of up to 90 minutes without disturbing your regular
alarm settings. The Nap timer settings are 5, 10, 15, 20, 30, 45, 60, 90 minutes and OFF The default Nap Timer setting is 5
minutes. To adjust the amount of nap time:
• Press the NAP button to activate the Nap Timer mode. The nap time display begins flashing.
• While the display is flashing press the NAP button repeatedly to adjust the nap time display
to the desired setting.
• Release the NAP button when the display is showing the desired nap time. The display will return to current time after 5
seconds. The new nap time setting becomes the new default and remains in the memory until you change it again.
• To check the amount of nap time remaining press the NAP button once. The display will show the amount of remaining
nap time for 5 seconds and then return to current time.
• When the Nap Timer counts down to “0”, the display flashes “n 0”, the alarm turns ‘On’
and gradually increases in volume to wake you gently. The alarm sound continues for one
hour and then shuts off automatically. To stop the nap alarm immediately, press the NAP
button again.
• To cancel the Nap Timer before it counts down to “0”, press the NAP button once to display
the amount of remaining nap-time and then press and hold the NAP button for 2 seconds
until the display shows “OFF”. The Nap Timer is cancelled.
After 5 seconds the display returns to current time.
Night Light
Press the NITELITE button to turn the night light ‘On’ at it’s brightest setting. Continue to press the NITELITE button to adjust
the brightness to the medium, low and ‘Off’ settings
Display Dimmer Control
If you prefer to reduce the display brightness for sleeping, press the SNOOZE bar once to select the medium setting or twice
to select the low setting. Press once more to restore the display to maximum brightness.
USB Charging Function
This Timex alarm clock is equipped with a convenient USB charging port on the back panel that allows you to recharge many
brands of mobile phones, portable music players, and other handheld devices that are supplied with USB charging cables.
The output rating of the USB charging port is 500mA.
To charge your device, connect the USB charging cable that was supplied with your handled device to the USB charging
port on the back panel of this alarm clock.
IMPORTANT! When connecting your USB cable to the USB port on this alarm clock please be sure that the
USB symbol (pleaon your plug is facing down when you insert the plug into the USB port.
Observe the charging indicator on your device to confirm that it is charging. If your device is not charging when the USB
selector switch is in the “A” position, slide the selector switch to the “B” position to begin charging.
Note: Charging time will vary depending on the charging current that your device requires. Therefore some devices will take
longer to charge than others.
OPERATING INSTRUCTIONS