Filter
Top Products
OPERATING INSTRUCTIONS
3
Adjusting For Daylight Saving Time (DST)
If you are currently observing Daylight Saving Time, set the DST switch on the back panel to the ‘On’ position. If you are
currently observing Standard Time, set the DST switch on the back panel to the ‘Off’ position.
Setting The Time
When the clock is connected to the AC outlet for the first time the display will show “12:00” and the PM indicator will be ‘On’,
indicating that the time displayed is 12:00 noon. Set the display to the correct time as follows:
1. Press and hold the TIME SET button on the back panel until the clock ‘beeps’ once and the display begins to flash.
2. While the display is flashing depress either the “ – “ (Back) or “ + “ (Forward) buttons on the top panel to adjust the time
display. The display will change rapidly when the buttons are depressed. When the display approaches the correct time,
release the buttons and then press repeatedly to make final adjustments to the exact minute. Observe the PM indicator
to confirm that the time is correct. If the PM indicator does not appear, the time on the display is ‘AM’.
3. When you are finished adjusting the display you may press the TIME SET button again to exit the setting mode. The clock
will ‘beep’ twice. Or after 10 seconds with no adjustment the clock will ‘beep’ twice and exit the setting mode automatically.
Setting The Wake Up Times / Activating The Alarms
The initial default setting for Alarm 1 is 6:00 AM. The initial default setting for Alarm 2 is 7:00 AM. The procedure for setting
the ALM 1 or ALM 2 wake up time is the same.
1. Press and hold the ALM 1 or ALM 2 button for 2 seconds. The clock beeps once and the currently set alarm time and
the ALM 1 or ALM 2 indicator begins to flash.
2. While the display is flashing depress either the “ – “ (Back) or “ + “ (Forward) buttons on the top panel to adjust the wake
up time display. The display will change rapidly when the buttons are depressed. When the display approaches the correct
wake up time, release the buttons and then press repeatedly to make final adjustments to the exact wake up minute.
Observe the PM indicator to confirm that the wake up time is correct. If the PM indicator does not appear, the wake up
time on the display is ‘AM’.
3. When you are finished adjusting the wake up time display you may press the ALM 1 or ALM 2 button again to exit the
setting mode. The clock will ‘beep’ twice. Or after 10 seconds with no adjustment the clock will ‘beep’ twice and exit the
setting mode automatically. The ALM 1 or ALM 2 indicator will remain in the display indicating that the alarm is set.
4. At the selected wake up time the alarm will turn on. Alarm 1 has a ‘single beep’ sound and Alarm 2 has a ‘double beep’
sound. You can tell which alarm has turned on by the sound that it makes. The alarm sound starts softly and gradually
increases in volume to wake you gently. The alarm will continue sounding for one hour and then shut off automatically
and reset itself for the following day.
5. To turn off the alarm sooner and reset it for the following day, press the NAP (ALM RESET) button. The Alarm sound stops
but the ALM 1 or ALM 2 indicator remains in the display and the alarm remains set for the same time on the following day.
6. To turn the alarm off completely so that it does not turn on the following day press either the ALM 1 or ALM 2 button. The
alarm sound stops and the ALM 1 or ALM 2 indicator disappears.