Filter
Top Products
5
FITTING BATTERIES
Unclip the two battery cover latches and remove the 1.
battery cover.
FITTING BATTERIES
Referring to the previous section, t 6 x ‘C’/’UM2’ batteries
into the battery compartment.
Remove the batteries if the unit will not be used for a long
time to avoid the danger of leakage.
NOTE: Never mix old and new batteries or batteries of
dierent types. Batteries should always be replaced as sets.
BATTERY OPERATION
BATTERY DISPOSAL
Dispose of used batteries with regard to the recycling
regulations in your area. Do NOT short circuit batteries or
throw them into water, the general rubbish or in a re.
Weak batteries can leak and damage the unit. Replace them
in good time!
Fit two ‘C’/’UM2’ batteries into the lower battery 2.
compartment, observing polarity as shown.
Fit 4 x ‘C’/’UM2’ batteries into the upper battery 3.
compartment, observing polarity as shown.
Re-t the battery cover.4.
AC MAINS OPERATION
POWER CONTROL/FUNCTION
CONNECTING POWER
Check that the mains voltage marked on the rating plate •
on the back panel is the same as the voltage in your
area.
Plug the AC power cord into the AC inlet•
Plug the mains plug into the wall socket and switch the •
mains power on.
The power control switch is combined with the function
selector, located on the left side of the unit.
To turn the radio on:
Slide the • FUNCTION SELECTOR to the RADIO position.
To play CD/MP3/USB/SD:
Slide the • FUNCTION SELECTOR to the CD/MP3/USB/SD
position.
To turn the cassette player on:
Slide the • FUNCTION SELECTOR to the TAPE/OFF position.
The power will switch on automatically when a cassette
function key is pressed.
To turn the unit o:
Slide the • FUNCTION SELECTOR to the TAPE/OFF position.
Check that the cassette player is set to ‘STOP’.