Filter
Top Products
User's Manual
10
Specications
Design
2 way
Bipole Conguration
Drive Units
HF: Waveguide loaded Neodymium
Ribbons
LF: 4.5-inch High Back-emf
Frequency Response
80 Hz to 40 kHz
Crossover Frequency
500 Hz (–6 dB)
Maximum Power
400 watts
Minimum Power
25 watts
Sensitivity (2.83 V/1 meter)
90 dB
Maximum Output
117 dB
Impedance
6 ohms nominal
Connections
1 pair gold plated spring binding posts
Dimensions
Height 8.25" (210 mm)
Width 12.18" (309 mm)
Depth 4.25" (108 mm)
Weight 8 lb (3.6 kg)
© 2008 Sunre Corporation.
All rights reserved. Sunre Corporation
reserves the right to improve its products
at any time. Therefore, specications are
subject to change without notice.
Manual 913-151-00 Rev A
Troubleshooting
The Cinema Ribbon CRM-2BIP dipole
loudspeakers are designed and built
to provide years of trouble-free perfor-
mance. Most problems that occur can
usually be solved by checking your setup,
or by making sure all components are
fully operational.
The following information will help you
deal with common problems you may
experience. If a problem persists, please
contact your Dealer for assistance.
Poor or no sound
• Check all the connections from the
loudspeaker to the amplier or receiver.
Swap loudspeakers around, and see
if the poor sound follows a particular
loudspeaker.
• Check that your amplier is not driven
too hard or is clipping. Even a low-pow-
ered amp driven into clipping can cause
distortion or damage your loudspeakers.
• Many processor/preamps can send
test tones through all the loudspeakers
in your system. Use this to adjust the
volume of each channel until they are
all playing at the same level. Make sure
that any bass management options are
set correctly, and any channels using
the Cinema Ribbon loudspeakers are
set to "small."
• If the system bass is weak only when
playing surround sources, check that
your processor is correctly set to decode
the surround modes, such as Dolby
Digital or DTS.
• Some DVD discs have a menu that
allows you to select which soundtrack
to play. Check that the correct surround
audio soundtrack is selected.