Filter
Top Products
96126 Second Edition 9
StorageTek Proprietary
Installation
Note: Refer to StorageTek’s Interop Tool for the latest connectivity
information. See page 2.
If necessary, refer to FlexLine’s hardware and software Installation Guides, or
to BladeStore’s Installation, Operation, and Maintenance Guide, P/N 96080 for
detailed installation information.
Refer to the Control Module/Array Module/Drive Module User’s Guides for
servicing information.
Note: The Hardware Cabling Guide provides cable routing information for
most FlexLine 200/300 Series storage system solutions. It help you
route the drive interface cables to the drive module ESMs.
Refer also to the F40 Cabinet User’s Guide, P/N 96100, and to the Installation
and Mounting Supplement, P/N 95972. These manuals can be found on the
CRC and on the engineering web page at:
http://gandalf.stortek.com/ctp/cabinet/
The following BladeStore configuration drawing should help you route drive
interface cables to blade modules (blade trays). This is the only storage
system not covered in the Hardware Cabling Guide. This information will help
you do an installation into a non-StorageTek cabinet.
Note: You should always make sure that there are two sets of redundant
loops (as shown in the following BladeStore example).
LC to LC Duplex
FC cables