Filter
Top Products
ICD-UX60/UX70/UX80 GB 3-283-649-11(1)
61
GB
Additional Information
* This is an approximation for the time
it takes to charge from no remaining
battery power to full battery power at
room temperature. It varies depending on
the remaining power and the condition
of the battery. It also takes more time if
the temperature of the battery is low, or
if the battery is charged while you are
transferring data to the IC recorder.
Disconnecting the IC
recorder from the AC outlet
Follow the procedures below; otherwise,
data may be damaged.
1 If you are recording or playing back
a message, press (stop) to put the
IC recorder into the stop mode.
2 Make sure that the operation
indicator is not ashing.
3 Disconnect the USB AC adaptor
from the AC outlet, and then
disconnect the IC recorder from the
USB AC adaptor.
Notes
While “ ” or “ ” is being displayed
instead of the remaining battery/charging
indicator, you cannot charge the battery.
Charge the battery in an environment with a
temperature of 5 °C - 35 °C.
While playing back messages using the built-
in speaker, you cannot charge the battery.
During recording (the operation indicator
lights or flashes in red) or accessing data (the
operation indicator flashes in orange),
the IC recorder should not be connected
to or disconnected from the USB AC
adaptor connected to the AC outlet.
the USB AC adaptor connected to the IC
recorder should not be connected to or
disconnected from the AC outlet.
Doing so may damage the data. If the
IC recorder is required to process a large
amount of data, the start-up window may
be displayed for an extended period of time.
This is not a malfunction of the IC recorder.
Wait until the start-up display disappears
from the display window.
While a USB AC adaptor (not supplied) is
being used, the remaining battery/charging
indicator does not appear in the display
window.