Filter
Top Products
24
Storing non-audio
data
You can transfer data from the hard disk of
your computer to the built-in flash memory
using Windows Explorer.
The built-in flash memory is displayed in
Windows Explorer as an external drive (for
example: as the D drive).
Notes
• You cannot operate the SonicStage software
while operating the data storage function of your
Network Walkman to use files stored in the built-
in flash memory. The error message “Cannot
access the Device/media.” will be displayed when
you try to operate both of them simultaneously.
• If you store a lot of non-audio data into the built-
in flash memory, the space for audio data is
reduced by the same amount.
Locking the
controls (HOLD)
You can protect your Network Walkman
against accidental operation by using the
HOLD function when carrying it.
Slide the HOLD switch in the
direction of the arrow.
All operation buttons are disabled.
If you press buttons while the HOLD switch
is on, “HOLD” blinks in the display.
To release the HOLD function
Slide the HOLD switch in the opposite direction of
the arrow.
G
r
o
u
p
M
o
d
e
HOLD switch