Filter
Top Products
when doing so. Do not wash your “WALKMAN” in a washing machine or ultrasound bath, etc.
Do not use detergent, chemicals, or wet wipes.
After washing your “WALKMAN,” wipe away the water on your “WALKMAN” using a soft cloth,
and then leave your “WALKMAN” in a well-ventilated shady place to dry. Do not dry your
“WALKMAN” using hot air from a hair dryer. Doing so may cause deformation and
deterioration of the water resistant performance.
Because the headphone sections (see the figure above) are not water-tight, sound quality of
your “WALKMAN” may deteriorate if water gets inside the headphones. If water gets in the
headphones, follow the procedures below to remove water. Do not use your “WALKMAN”
until it dries completely.
Wipe the moisture off your “WALKMAN” using a dry cloth.
Put a dry cloth over the aperture of the headphone, and shake the headphone about 20
times.
Put a dry cloth under the headphones, and leave your “WALKMAN” at room temperature
for about 2 or 3 hours.
The rubber gasket used in the USB jack cover may become cracked or deformed by prolonged
use or due to use in certain environments. We recommend that you check the condition of the
USB jack cover periodically to maintain the water resistant performance.
USB jack covers matching each individual “WALKMAN” color are available as repair parts for a
fee.
For more details, consult your nearest Sony dealer or Sony Service Center.
To change the USB jack cover
Pull the USB jack cover off to remove it.
Push the tab (A) of the new USB jack cover back into the same position.
If the USB jack cover comes off, you can put it back on by pushing it back into the same position
as that shown in the right figure (
.)
Go to page top
Copyright 2011 Sony Corporation
18