Filter
Top Products
55
Operating Instructions
* A new track mark is added at the point
where you pressed P, and the recording
will be marked with the new track number
when you resume recording.
** Once you open the lid, the point to start
recording will change to the beginning of the
first track. When recording on a recorded
MD, check the point to start recording on the
display.
If the recording does not start
Make sure the MD is not record-protected.
If the tab at the side of the MD is open,
slide it back so the tab is visible.
1 Attach the recorder to the station.
1 Place the right side of the
recorder.
2 Push down until it clicks.
Make sure to attach the
recorder in the right way. Pushing
with force may cause a
malfunction.
2 Insert a recordable MD.
1 Slide the (open) switch and
open the lid.
2 Insert a recordable MD with
the label side facing up. and
press the lid down to close.
3 Select the input source.
Set (input select) switch to
the connected input.
Select " " to record
signals from
(OPTICAL IN).
Select " " to record signals
from (LINE IN).
4 Select recording start point.
If you want to add a recording to the
end of the previous recording, press
(end search).
(If you want to start recording from the
beginning, skip this step).
5 Start recording.
1 Slide the (record) switch
to the right while pressing its
button.
"REC" lights up and recording starts .
2 Play the sound source.
To stop recording, press p.
Do not move or jog the recorder or disconnect
the power source while the "TOC EDIT"
indication is flashing in the display.
zMD playing
Playing an MD right away!
See the illustrations in the Japanese text
(pages 12 to 13). The following explains
how to play MDs on the recorder while
detached from the station.
Before playing, insert the dry batteries or
rechargeable battery into the recorder (see
page 30).
1 Detach the recorder from the station.
1 Slide the
(detach recorder) switch.
2 Connect the remote controller-
equipped headphones
(supplied) to the 2/
jack.
2 Insert an MD.
1 Slide the (open) switch
and open the lid.
2 Insert an MD with the label
side facing up, and
press the lid down to close.
3 Start playing.
1 Press(.
A short beep sounds in the
headphones.
2 Press the (volume) -/+
buttons to adjust the volume.
You can check the volume in
the display.
To stop play, press p.
A long beep sounds in the headphones.
To
Pause
Record over
partway through
the previous
recording
Remove the MD
Turn power off
Press
P*
Press P again to
resume recording.
(, + or = to
find the start point of
recording and press
p to stop. Then slide
the (record)
switch.
p
,then slide the
(open) switch and
open the lid.**
(Power)