Filter
Top Products
Additional Information
31
Beep Output During
Operations
Your deck can output various beeps to allow you to
verify deck operations by sound.
The beeps are output from both the deck itself and the
headphones.
Operation
The deck has been turned off.
The deck has been turned on.
One short beep (high)
Two short beeps (high)
r was pressed but the MD is full.
An operation button was pressed
with no MD loaded.
Three short beeps
(high), followed by one
continuous beep (high)
One continuous beep
(high)
r was pressed and the deck has
changed to recording pause.
Consecutive beeps (low)
are emitted, one for each
10 minutes of remaining
time on the MD*,
followed by single beeps
every few seconds.
fl (· or P) was pressed and
the deck has started recording.
One short beep (high)
The deck is recording or in
recording pause and the peak
level meter level has exceeded the
recommended level**
(“OVER” lights up).
One continuous beep
(low)
The deck is recording and the
remaining time on the MD has
dropped below 3 minutes**.
Several short beeps
(high)
fl (· or P) was pressed and
the deck has started playing.
One short beep (high)
p was pressed. One short beep (low)
PLAY MODE was pressed while
the deck is stopped, and
continuous (normal) play mode
has been selected (canceling
Shuffle or Program Play mode).
One short beep (low)
Beep sound
EDIT/NO was pressed while the
deck is recording, and
“LevelSync ?” has appeared in the
display **.
One short beep (high)
One short beep (high)
EDIT/NO was pressed while the
deck is stopped, and “All Erase ?”
has appeared in the display.
One short beep (high)EDIT/NO was pressed while the
deck is playing, and “Erase ?” has
appeared in the display.
* One beep for each 10 minutes of remaining time (e.g., one
beep for 10 to 20 minutes, two beeps for 20 to 30 minutes,
and three beeps for 30 to 40 minutes). No beep is output
for a remaining time of 10 minutes or less.
** This beep is output only through the headphones; no beep
is output from the deck.
Switch BEEP to ON.
A high- or low-pitched beep is output to indicate the
following operations.
Rear of the deck
LINE
(ANALOG)
DIGITAL
BEEP
IN OUT
L
R
IN
OUT
ON
OFF
BEEP