Filter
Top Products
156
Others
Symptom Cause and/or Corrective Actions
• Your VCR and/or video camera recorder is not set correctly.
c Make sure the input selector of the VCR is set to LINE. Also,
make sure the power switch of the video camera is set to
VTR/VCR (p. 103).
• The IR SETUP code or PAUSE MODE is not set correctly.
c Select the correct IR SETUP code and PAUSE MODE,
according to your VCR. Then confirm VCR operation with
the IR TEST function. (p. 103, 104)
• The input selector on the VCR is not set correctly.
c Set the selector correctly, and check the connection between
the VCR and your camcorder. (p. 111)
• The camcorder is connected to DV equipment other than of
Sony using the i.LINK cable (DV connecting cable).
c Keep the connection, and follow the procedure on page 117.
• Setting programme on a blank portion of the tape is attempted.
c Set the programme again on a recorded portion (p. 120).
• The synchronisation of your camcorder and the VCR is not
adjusted.
c Adjust the synchronisation of the VCR (p. 118).
• Your camcorder was connected to your computer with the USB
cable before installing the USB driver, so the driver was not
recognised by the computer.
c Uninstall the unrecognised driver, and then reinstall the
driver. (p. 127)
• The USB driver is not installed correctly.
cUninstall the unrecognised driver, and then reinstall the
driver. (p. 127)
• Your computer’s operating system is Windows 98 or earlier.
• The USB cable was not connected before starting up the
application software.
c Connect the USB cable before starting up the application
software. (p. 130)
• COMMANDER is set to OFF in the menu settings.
c Set it to ON. (p. 143)
• Something is blocking the infrared rays.
c Remove the obstacle.
• The batteries are inserted in the battery holder with the
+ – polarities incorrectly matching the + – marks.
c Insert the batteries with the correct polarity. (p. 198)
• The batteries are dead.
c Insert new ones. (p. 198)
*
1)
CCD-TRV107E/TRV108E/TRV208E/TRV408E only
*
2)
DCR-TRV140E only
*
3)
CCD-TRV107E/TRV208E/TRV408E, DCR-TRV140E only
Types of trouble and their solutions
The Remote Commander supplied
with your camcorder does not
work.*
3)
Digital program editing does not
function.*
2)
You cannot install the USB driver.*
2)
Easy Dubbing does not function.*
1)
USB Streaming function does not
work.*
2)