Filter
Top Products
AIR-SA20PK.GB.4-117-793-32(1)
32
GB
Others
Troubleshooting
1
Make sure the power supply
cord and the power cord are
correctly and rmly connected.
2
Find your problem in the
checklist below, and take the
indicated corrective action.
If the issue persists, contact your
nearest Sony dealer.
When bringing the product in for
repairs, be sure to bring in the entire
system (the main unit, the sub units
and wireless transceivers).
is product is a system product,
and the entire system is needed to
determine the location requiring
repair.
If “PROTECT” appears on the display of
the main unit
Set the POWER switch on the rear panel
to “OFF” to turn o the unit, and then
unplug the power supply cord. Aer
checking that there is no indication on
the display, reconnect the power supply
cord and set the POWER switch to “ON”
to turn on the unit. If the issue persists,
contact your nearest Sony dealer.
If the STANDBY indicator on the sub
unit ashes
Immediately unplug the power cord,
and check if anything is blocking the
ventilation holes on the rear panel of the
unit.
Aer the STANDBY indicator stops
ashing, reconnect the power cord, and
turn on the unit. If the issue persists,
contact your nearest Sony dealer.
General
The remote does not function.
Remove any obstacles between the
remote and the remote sensor, and
position the main unit and the sub
units away from uorescent lights.
Point the remote at the remote sensor.
Move the remote closer to the main
unit or the sub units.
e remote control function of the sub
unit is o. Turn on the remote control
function (page 31).
Check whether you are using the
remote for the main unit to operate the
main unit and the remote for the sub
unit to operate the sub unit.
The S-AIR indicators on the main unit
and the sub units are turned o.
Check that the power supply cord and
the power cord are connected securely
and the main unit and the sub units are
turned on.
Check that the supplied wireless
transceivers are inserted securely to the
main unit and the sub units (page 17).
Connecting the main unit and the
sub units is not possible. (The S-AIR
indicator on the main unit is turned
o and/or the S-AIR indicator on the
sub unit ashes.)
Check that the supplied wireless
transceivers are inserted securely to the
main unit and the sub units (page 17).
If you use another S-AIR main unit,
place it more than 8 m away from the
main unit.
Conrm the S-AIR IDs of the main
unit and the sub units.
e main unit is paired with another
S-AIR sub unit. Pair the main unit with
the sub unit you are using.