Filter
Top Products
23
Basic Operation
– Recording –
Recording
Helpful tip when attaching a label
When attaching a label to a MiniDisc cartridge, be sure to
note the following. If the label is not attached properly, the
MiniDisc may jam inside the unit and it may not be pos-
sible to remove it.
● If the label peels off or partially lifts
away, replace it with a new one.
● Do not put a new label on top of an
existing one.
● Attach the label only in the specified location.
To prevent recorded MiniDiscs from be-
ing erased accidentally
Slide the accidental erase prevention tab, located
on the side of the MiniDisc, in the direction indicated
by the arrow.
The MiniDisc will then be protected against accidental era-
sure.
To add a recording to such a MiniDisc, slide the ac-
cidental erase prevention tab back to its original po-
sition.
Recording preventedRecordable
About sampling rate converter
This portable MD incorporates a sampling rate converter
meaning it can record from digital radios or DAT tape re-
corders.
Note for digital recording
You cannot copy a MiniDisc that you recorded from digital
inputs to another MiniDisc or DAT. It is prevented by the
SCMS (Serial Copy Management System). Recording from
analog inputs is not affected.
CD player,
MiniDisc
player,
etc.
Digital signals
Digitally recorded
MiniDisc
Cannot record
Digital
connection
Digital
connection