Filter
Top Products
Error messages Meaning Remedy
BATT EMPTY
●The battery has run down. ●Charge the rechargeable battery or
replace the alkaline batteries (or use
the AC adaptor for power).
BLANK DISC
●Nothing is recorded. ●Replace the disc with a recorded
disc.
Can’t COPY
●No copy can be made because of
the SCMS copyright system.
●Record using the analog cable.
Can’t EDIT
●A track cannot be edited. ●Change the stop position of the
track and then try editing it.
Can’t REC
●Recording cannot be performed
correctly due to vibration or shock
in the unit.
●Re-record or replace it with another
recordable disc.
Can’t WRITE ●Editing is impossible. ●Check the number of tracks.
DEFECT
●The disc is scratched. ●If the sound you hear is not correct,
try recording again.
●Replace the disc with another
recordable disc.
Din UNLOCK ●Poor connection of the digital cable. ●Connect the digital cable securely.
DISC ERROR ●The disc is damaged. ●Reload the disc or replace it.
DISC FULL
●The disc is out of recording space. ●Replace it with another recordable
disc.
HOLD
●The unit is in the safety mode. ●Return the HOLD switch to its
original position.
LOCKED
LOCK ERROR
●The EJECT lever was moved
during recording or editing.
●Turn off the power and remove the
MiniDisc.
NO DISC ●A disc has not been loaded. ●Load a disc.
PB DISC
PROTECTED
●The disc is write protected.
●You tried to record on a playback-
only disc.
●Move the write protection knob
back to its original position.
●Replace it with a recordable disc.
POWER ?
●Improper power is being supplied. ●Use one of the specified power
sources.
SORRY
●Since a track number is currently
being located or written to, the unit
cannot accept your command.
●Wait and then try the operation
again.
SYSTEM ERR
●The unit is malfunctioning and will
require service.
● For service, contact your local
Sharp authorized service center.
TEMP OVER
●The temperature is too high. ●Turn off the power, and wait for the
unit to cool.
TOC ERROR
●A large portion of the disc has been
damaged.
●Replace it with another recorded
disc.
TOC FULL
●There is no space left for recording
character information (track names,
disc names, etc.).
●Replace it with another recordable
disc.
Tr. Protect
●The track has been protected from
being erased.
●Edit the track with the device on
which it was recorded.
U TOC ERROR
●A large portion of the disc has been
damaged.
●There is an error in the recorded
signal.
●Replace it with another recorded
disc.
●Erase all of the signal errors, and
then try recording again.
? DISC
●A disc which contains data other
than music was played.
●There is an error in the signal from
the disc.
●A disc which contains non-music
data cannot be played.
●Replace it with another recorded
disc.
ERROR MESSAGES
39
MD-MS702