Filter
Top Products
● Check whether the total number of
tracks on the newly recorded MiniDisc
matches the total number of tracks on
the master MiniDisc. If they do not
match each other, combine or divide
tracks using the edit operation. (Pages
27–28)
● This function can not be performed
from pre-recorded (playback only) Mini-
Discs.
2 When the recording is complete,
remove the newly recorded MiniDisc
and load the master MiniDisc into the
MD-MS702.
● Do not mistake the master MiniDisc for
the newly recorded MiniDisc.
3 While in the stop mode, press the
EDIT/A.MARK/TIME MARK button to
select “NAME STAMP”.
4 Press the ENTER/F.PLAY/SYNCHRO
button.
● To cancel the operation, press the
■/:OFF button.
5 Press the ENTER/F.PLAY/SYNCHRO
button.
● The character information of the master
MiniDisc is being read.
6 When the unit displays “CHANGE MD”,
remove the master MiniDisc.
● Remove the master MiniDisc without
turning off the power. If you do, the
operation will be canceled.
7 Load the newly recorded MiniDisc into
the MD-MS702.
● To cancel the operation, press the
■/:OFF button.
8 Press the ENTER/F.PLAY/SYNCHRO
button.
● The unit will finish recording the char-
acter information and enter the stop
mode.
Note:
● If the total number of tracks on the
master MiniDisc does not match the
total number of tracks on the newly
recorded MiniDisc, the unit will display
“Can’t WRITE” and the power will be
turned off.
If this happens, adjust the total number
of tracks on the newly recorded Mini-
Disc using the edit operation, and then
try again from step 2.
6
5
4
3
31
MD-MS702