Filter
Top Products
28
TROUBLESHOOTING GUIDE
Symptom Possible Cause
Station not tuned properly for
FM or AM.
FM: Wire aerial is not
positioned correctly .
Loop aerial is not positioned
correctly.
FM station is mono or station
signal is weak.
Function is not set to Tuner.
Volume at minimum.
Solution
Retune FM or AM broadcast
station.
Extend FM wire aerial.
Reposition so that the best
reception is obtained.
Extend FM aerial. Try other
strong stations.
Pres s MODE button to select
Tuner func tion.
Increase Volume.
Radio
Noise or sound
distorted on FM or
AM broadcasts.
FM STEREO indicator
does not light.
AM or FM, no sound.
iPod Player
Unit does not respond
(no power)
AC adaptor is not plugged into a
wall outlet or the connector is not
plugged into the DC IN jack
on the back of the unit.
Plug the AC adaptor into a wall
outlet and plug the connector into
the DC IN jack on the unit.
Make sure the dock insert is the
proper fit for the
iPod
.
Remove the iPod from the dock
and check for obstruction on the
connections in the dock and on the
iPod,Then reseat it in the dock.
Remove the iPod from the dock
and check for obstruction on the
connections in the dock and on the
iPod,Then reseat it in the dock.
Please make sure your
iPod
is
working properly before docking
into the unit. Please refer to the
iPod
manual for details.
This unit cannot control those
iPod
or other devices.
Please make sure your
iPod
is
working properly before docking
into the unit. Please refer to the
iPod
manual for details.
Remove the iPod from the dock
and check for obstruction on the
connections in the dock and on the
iPod,Then reseat it in the dock.
iPod does not
dock porperly
Using no or wrong iPod
insert
iPod did not install properly
iPod does not
respond to the unit.
iPod is not installed
properly
iPod is locked up
Using first or second generation
iPod
,
iPod Shuffle or
other devices.
iPod did not
charge up
iPod is not installed
properly
iPod is locked up/frozen
iPod
battery has problem
Remarks:
If troubleshooting(see above)does not eliminate the problem, disconnect the unit from the
mains power and re-connect after a few seconds. Resetting causes the unit to restore its
factory default setting and results in all the setting made by the user being deleted.