Filter
Top Products
In addition to real time, a dual time can be programmed into the radio.
1.Press MEMO SCAN (DUAL TIME) button, display will flash “ ”
2.Press ENTER button within 7 seconds, the display “ ” will stop flashing.
3.Press ENTER button again, the “ ”dual time symbol flashes, whilst the “ ” is flashing,
set the dual time by pressing the numbered buttons.
4.The rest of the operation is same as setting real time.
5.Press DUAL TIME button again ENTER button to return to real time.
Note: a. To temporarily change between real and dual time mode, press DUAL TIME button.
The “ ” dual time symbol and dual time will be shown in the display. After
approximately 7 seconds, the display will return to show real time.
b. To permanently change the display to dual time, press DUAL TIME button followed
by the ENTER button, “ ”Dual time symbol will appear on the display.
c. To permanently change the display back to real time mode, press DUAL TIME button
followed by the ENTER button. The “ ”symbol will be removed from the display.
Zero seconds set
Press the “0”button for more than 2 seconds the display of seconds will be reset second to 00.
Waveband selection
There are three waveband selection by pressing BAND button
Waveband Frequency coverage Aerial Type
FM 87.50-108MHz Telescopic
Fully extend the aerial, angle
and rotate for best reception
MW 520--1710kHz Internal
Rotate for best reception
SW 2.3-26.10MHz Telescopic
Fully extend the aerial for best reception
Stations may selected by using any of the five different available tuning methods:
Direct Tuning, Manual tuning ,Scan Tuning ,Memory Recall Tuning and APS on MW and FM
bands.
Direct tuning
Example : To tune to 100.70 MHz on the FM band.
1.Press the POWER on/off button to turn on the radio.
2.Select the required FM by pressing BAND button.
3.Press the button marked ENTER-Freq./Time, display show”- --“.
4.Press the numbered buttons marked 1,0,0,7.Then press ENTER button again, the
frequency will now appear in the display .
Note: There is no decimal point, therefore before you press the number button, make sure you
have selected the required waveband , otherwise the operation may switch to other
waveband.
5.Extend the aerial fully and rotate for best FM reception.
6.Adjust the Volume Control for comfortable listening
7.When selecting a stereo FM station and using stereo earphones, make sure the FM model
switch is in the stereo position.
5
Setting the dual time