Filter
Top Products
5 – Battery Indicates the battery status
6 – Track Length Displays the elapsed time of currently playing track
7 – Progress Meter Displays status of the currently playing track
8 – Play/Pause To play, resume, or pause currently playing track
9 – Track Name Displays name of currently playing track
10 – Album Name Displays album name of the currently playing track
11 – Artist Name Displays artist name of the currently playing track
Li-Polymer Battery
The Sansa c200 player comes with a replaceable and rechargeable lithium polymer
battery. Remember to fully charge the battery before using the device for the very
first time. It takes approximately 3.5 hours to fully charge the battery. The
battery can be charged through the USB port of the computer, the car adapter (not
included) USB port, or the USB-AC adapter (not included) port.
Note:
• Some low-power USB ports may not be able to provide enough charge power.
• The Li-polymer rechargeable battery may eventually need to be replaced as they
have limited charge cycles.
• To purchase a replacement battery, visit your local retailer or www.sandisk.com
Charging battery over USB
1) Connect the larger end of the USB cable into the dock connector of the
Sansa player.
2) Connect the smaller end of the USB cable to an available USB port on the
computer.
3) The Sansa c200 display screen will say Connected.
4) To stop recharging, disconnect the cables.
Note: The computer must be on for most USB ports to charge your battery.
Charging battery with AC power adapter
1) Connect the larger end of the USB cable into the dock connector of the
Sansa player.
2) Connect the smaller end of the USB cable to the AC-USB adapter.
3) Plug the AC-USB charger into a power source.
4) To stop recharging, disconnect the cables.
How to replace the battery
1) Press in on the tab of the battery compartment then slide to the right to
remove the cover.