Filter
Top Products
ENG-21
C
ONNECTIONS
You must have the antenna/cable
connected for the Auto Clock to set
Connecting a Power Cord & Auto Setup
1
Your DVD-VCR's power cord should be plugged
into a standard 120V/60Hz wall outlet. Avoid
pressing any buttons on the remote control or on
the unit during Auto Setup. While your DVD-VCR
is running Auto Setup, “Auto” will blink. When
Auto Setup is complete, the current time will be
displayed on the front panel. If Auto Setup fails to
locate a channel to set the clock, you should set
the clock manually. (See pages 24 to 25.)
2
Turn on the power by pressing the POWER
button on the remote control or on the front
panel.
3
Turn on your TV by pressing the POWER button
on the TV remote control.
4
Press the input selector on your TV remote until
the signal from the DVD-VCR appears.
00956B V8650 XAA_Eng1 31/3/06 06:58 Page 21