Filter
Top Products
ENG-20
C
ONNECTIONS
Connection to an Audio System (Dolby digital, MPEG2 or DTS
Amplifier)
1
Using a coaxial cable or optical cable (not
included), connect the DIGITAL AUDIO OUT
(COAXIAL
or OPTICAL) terminal on the rear of
the DVD-VCR to the
DIGITAL AUDIO IN
(COAXIAL or OPTICAL) terminal of the Amplifier.
3
Turn on the DVD-VCR, TV, and Amplifier.
4
Press the input select button of the Amplifier to
select external input in order to hear sound from
the DVD-VCR.
Refer to your Amplifier's user manual to set the
Amplifier's audio input.
Notes
- When you connect the DVD-VCR to DTS Amplifier and play a DTS disc, set the DTS to On in Audio
Setup menu. If it is set to Off, sound will not be heard, or there will be a loud sound.
- Please turn the volume down when you turn on the Amplifier. Sudden loud sound may cause damage
to the speakers and your ears.
- Please set the audio in the menu screen according to the Amplifier. (See pages 58 to 59)
- The position of terminals may vary depending on the Amplifier.
Please refer to the user's manual of the Amplifier.
- Only audio from the DVD player can be heard when connection is made via the Optical or Coaxial jack. You
must have the analog L and R Audio Out connection to hear VCR audio. (See page 17)
2
Using the video signal cable(s), connect the
S-VIDEO or COMPONENT OUT terminals on the
rear of the DVD-VCR to the S-VIDEO or
COMPONENT OUT terminal of your TV as
described on pages 15 to 18.
Dolby digital or
DTS Amp.
Coaxial Cable
(not included)
Optical Cable
(not included)
00956B V8650 XAA_Eng1 31/3/06 06:58 Page 20