Filter
Top Products
GB
9
GB
8
How to connect a COAXIAL TYPE antenna.
Connect a 75Ω antenna to the FM antenna terminal.
Plug the connector on the supplied FM antenna supplied into the coaxial socket (75Ω) marked FM on the rear of the
system.
Follow the instructions given on Page 14 to tune into a radio station, and determine the best position for the antenna.
If reception is poor, you may need to install an outdoor antenna.
To do so, connect an outdoor FM antenna to the FM socket on the rear of the system using a 75Ω coaxial cable (not
supplied).
Connecting the FM Antenna
You can view various functions available on your sys-
tem.
Press the DEMO/DIMMER button.
Result:
The available functions are listed in turn on
the display.
All these functions are described in detail in this book-
let. For instructions on how to use them, refer to the
appropriate sections.
To cancel this function, press DEMO/DIMMER again.
2
1
DEMO Function
DEMO/DIMMER
You can adjust the brightness of the display depend-
ing on the surrounding lighting conditions.
Press the DEMO/DIMMER button twice.
Your selection switches each time the button is
pressed: DIMMER ➞ DIMMER OFF.
1
DIMMER Function
DEMO/DIMMER
Your system is equipped with a clock which allows
you to turn your system on and off automatically.
You should set the clock:
When you first purchase the micro component system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the
required options. If you exceed this time, you must
start again.
Switch the system on by pressing ( ) .
Press TIMER/CLOCK twice.
Result:
CLOCK is displayed.
Press SET.
Result:
The hour flashes.
To... Press...
Increase the hours
Decrease the hours
When the correct hour is displayed, press SET.
Result:
The minutes flash.
To... Press...
Increase the minutes
Decrease the minutes
When the correct time is displayed, press SET.
Result: "TIMER" appears in the display.
The current time is now set.
You can display the time, even when you are using
another function, by pressing TIMER/CLOCK once.
Setting the Clock
1
2
3
4
5
6
7
DEMO/DIMMER
TUNER MEMORY
DNSe EQ
REPEAT
SET
SET
2
3,5,7
1
2
4,6
4,6
The cooling fan dissipates the heat generated inside the unit so that the unit can be operated normally. The cooling fan
is activated automatically to supply cool air to the unit.
Please observe the following cautions for your safety.
•
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise and may damage it.
•
Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a newspaper or cloth, heat may
build up inside the unit and fire may result.)
Cooling Fan