Filter
Top Products
To obtain the best possible results from your micro
component system, you must clean the following ele-
ments regularly:
The outer casing
The compact disc player
Always unplug the system from the wall outlet:
Before cleaning it
If you are not going to be using it for a long
time
Outer Casing
Clean the outer casing regularly using a soft cloth and a
light detergent. Do not use abrasive powders, liquids or
aerosol cleaners. Never let any liquids get into the system.
Compact Disc Player
Before playing a compact disc, clean it with a special
CD cleaning agent. Do not use the same cleaning
agents as for vinyl LP records.
Carefully wipe the disc from the center outward.
Regularly clean the player with a special cleaning disc
(available from your local dealer).
If you will not be using the remote control for a long
time, remove the batteries to prevent corrosion.
Do not be use this system in an excessively dusty
environment or subject it to shock or extreme
heat(close to heating appliances or in direct sunlight
ect).
If the unit emits an unpleasant odor when in use,
unplug it from the power supply and contact a
Samsung authorized service center.
Cleaning Your Micro Component
System
1
2
The following diagrams illustrate the precautions to be
taken when using or moving your micro component
system.
Safety Precautions
Ambient operating conditions:
Ambient temperature 41°F-95°F
Humidity 10-75%
Do not expose the unit to direct
sunlight or other heat sources.
This could lead to overheating
and malfunction of the unit.
Do not place potted plants or vases
on top of the unit. Moisture entering
the unit could lead to dangerous
electric shock and can cause equip-
ment damage. In such events imme-
diately disconnect the main plug
from the outlet.
Remove the batteries from the
remote control, if not used for any
extended period.Leaking batteries
can cause serious damage to the
remote control.
When using headphones, take care
not to listen at excessive volumes.
Extended use of headphones at
high volumes may lead to hearing
damage.
Do not place heavy items on the
power cord.If the power cord is
damaged it may lead to equip-
ment damage(fire hazard) and
may cause an electric shock.
Do not remove any equipment
panels. The inside of the unit
contains live components, which
cause electric shock.
During thunderstorms, dis-
connect the main plug from
the outlet voltage peaks
due to lightning could dam-
age the unit.
VOLUME
UP
DOWN
18
19
If the above guidelines do not allow you to solve the problem,
take a note of:
The model and serial numbers, normally printed on the rear
of the system
Your warranty details
A clear description of the problem
Then contact your local dealer or SAMSUNG authorized service.
Handle your compact discs with care. Always hold them
by the edges to avoid leaving fingerprints on the shiny
surface.
When you have finished playing a compact disc, always
put it back in its case.
Do not fix paper or adhesive tape to the discs and do
not write on the label.
Clean them with a special-purpose cloth.
Store your compact discs in a clean place, out of direct
sunlight, where they will not be exposed to high temper-
atures.
Always use compact discs marked
.
Precautions When Using Compact
Discs
Troubleshooting
COMPACT
DIGITAL AUDIO
Problem
The system does not
work
There is no sound
The Timer does not work
The unit does not work,
even after following the
Troubleshooting steps
above.
The compact disc player
does not start playing
Reception is poor or no
radio stations are
received at all
G
E
N
E
R
A
L
C
D
R
A
D
I
O
Checks/Explanation
• The power cord is not correctly
plugged into a wall socket or the
wall socket is not switched on.
• The remote control batteries need
replacing or the polarity is incor-
rect..
• The button has not been
pressed.
• The volume has been completely
turned down.
• The correct function (TUNER,
MP3/WMA-CD/CD, AUX) has not
been selected.
• You have connected a set of ear-
phones.
• The MUTE button has bee
pressed.
• The timer has been stopped by
pressing TIMER ON/OFF.
• Press the STOP ()button for 5
seconds to reset the unit.
• Press the STOP ()button for 5
seconds with No disc in the unit to
reset the unit.
• The CD function has not been
selected.
• The disc has been inserted face
down or is either dirty or scratched.
• The laser sensor is dirty or dusty.
• The system has not been installed
on a flat, horizontal surface.
• Condensation has formed in the
player; leave the system in a
warm, airy room for at least one
hour.
• The TUNER function has not been
selected.
• The radio frequency has not been
correctly selected.
• The antenna has been disconnect-
ed or is not facing the right way.
Turn it until you find the best orien-
tation.
• You are in a building that blocks
radio waves; you must use an out-
side antennal.
It always takes a little time to become familiar with a
new player.
If you have any of the problems listed below, try the
solutions given. They may save you the time and
inconvenience of an unnecessary service call.
GB
GB