Filter
Top Products
ENGLISH
28
Viewing a Video from an External Component
Use the procedure below to view a video from a VCR or camcorder on your DVD player.
1. Connect the external component according to the procedure outlined on page 17.
2. Turn on the external component.
3. Turn on the DVD player.
4. Press the DVD/M.STICK/AV-IN button to set the AV-IN mode.
5. Press the PLAY button on the external component.
Caution
•
Power is not supplied from this device to the connected DVD player.
•
When not using your DVD player, always remove all connecting cables from the video or
audio input/output jacks.
•
If no signal is input for more than 5 minutes while in the input mode, this unit enters
the standby mode.
If the player is left in pause mode
•
If the ‘PAUSE’ mode continues for more than 5 minutes, the unit will be automatically switch to ‘STOP’.
•
If the ‘STOP’ mode continues for more than 1 minute, it will automatically switch to
‘FADE IN FADE OUT’.
•
If the ‘FADE IN FADE OUT’ mode continues for more than 4 minutes, the power will be shut off auto
matically.
To view a video from an external component
AV-IN