Filter
Top Products
13
Operating your radio - Search tuning FM
1. Fully extend the wire aerial.
2. Press the Standby button [On/Off button on the remote control] to
switch on your radio.
3. Press and release the Function button until the FM band is se-
lected.
4. Press the Skip Up button and then press the Auto scan button,
your radio will scan in an upwards direction (low frequency to high
frequency) and stop automatically when it fi nds a station of suffi cient
strength.
5. After a few seconds the display will update. If the FM band is selected
the display will show the station name if available. The display will
also show "St" and "RDS" after the station name on the upper line if
the station is with stereo and RDS function.
6. To fi nd other stations press and hold the Autoscan button as before.
7. To scan the FM band in a downwards direction (high frequency to low fre-
quency) press the Skip Down button and then press Auto scan button.
8. When the waveband end is reached your radio will recommence tuning
from the opposite waveband end.
9. Adjust the Volume to the required settings.
10. To switch off your radio press the Standby button.
2
3
4
7
9
10
4,6,7