Filter
Top Products
21
Specifications
Power Requirements
Mains AC 230 volts, 50Hz
only
Frequency Coverage
FM 87.5-108MHz
MW 522- 1629kHz
LW 153- 279kHz
Loudspeaker 75mm x 100mm 8ohms
Output Power 800 mW
Headphone socket 3.5mm dia
Aerial System FM Wire aerial
MW Built-in Ferrite aerial
LW Built-in Ferrite aerial
Troubleshooting
1. If the time does not set automatically it may be necessary to rotate
your clock radio to a position giving better reception of the MSF
signal.
2. It is recommended that your clock radio is placed as far away as
possible from any sources of interference such as computers or
televisions, etc.
3. To re-synchronise with the MSF time signal, press and hold down the
time button (4 seconds) until the MSF indicator
begins to
flash. The MSF indicator will continue to flash whilst synchronisation
takes place. Synchronisation is complete when the MSF indicator
stops flashing.
At certain times of the year the MSF transmitter closes down for
maintenance. During this time the clock will not automatically
set. Recorded information on transmitter status can be obtained
on 020 8943 6493.
3