Filter
Top Products
THE DIGITAL CD CLOCK RADIO
Protection against mains power failures:
1. Remove battery compartment door (located on
the back of the radio) by applying thumb pressure
to area indicated on battery door and then lift the
door out and off the cabinet.
2. Connect a 9-volt battery connector plug. (6LR61
or NEDA 1604A)
3. Insert battery in the compartment and replace
the compartment door.
Setting time
Battery compartment at the
backside of the unit
NOTE: Alkaline (6LR61/NEDA 1604A) batteries are recommended. Carbon-zinc battery may be
used but memory holding time will be substantially reduced. Memory holding time for a
fresh alkaline battery is approximately 8 hours (if radio or alarm are not operated) which
should take care of short, nuisance-type AC power failures. To preserve battery life, the unit
should remain plugged into an AC outlet. As the battery gets older, its voltage drops and
memory may be lost. Be sure to replace the battery periodically. Battery should be removed if
the unit will be stored for more than one month. Leaky battery can badly damage the clock
radio.
You may slide on the left side of the unit to vary the LED display
brightness.
1
Press and hold
1
Press or
2
NOTENOTE
NOTENOTE
NOTE:
1. Press and hold or to skip fast
2. The AM LED indicator will light to show AM time
OFF DIMMER O
N
TIME
SET
<<
SKIP
>>
SKIP
<<
SKIP
>>
SKIP
TIME
W AKE 1
W AKE 2
SNOOZE
<<
SKIP
>>
SLEEP
SET
SKIP
SET
SET
Adjusting display brightness
RP3753 EN-US 3/13/01, 4:11 PM4