Filter
Top Products
Connecting VHF and UHF antennas, continued
Antennas with 75-ohm round leads
1 Plug the lead into the terminal on the bottom of the rear panel.
Separate VHF and UHF antennas
If you have two separate antennas for your TV (one VHF and one
UHF), you must combine the two antenna signals before connecting
the antennas to the TV. This procedure requires a combiner attach-
ment. You’ll find the type of combiner you need at an electronics store.
1 Connect both antenna leads to the combiner.
Plug the combiner into the terminal on the bottom of the rear panel.
Connecting cable TV
Choose one of the sections below for connecting a cable system.
✓ This TV is cable-ready; you don’t need a converter for basic cable channels.
Cable without a Converter Box
To connect cable without a converter box:
1 Plug the incoming cable into the TV’s antenna terminal.
Cable with a Converter Box
To connect cable with a converter box to descramble channels:
1 Find the cable that is connected to the ANTENNA OUT (also named
ANT OUT, VHF OUT, or, OUT) terminal on your converter box.
2 Connect the other end of this cable to the TV’s antenna terminal.
✓ If you only need to use the cable box to descramble a few channels, contact
your cable company for suggestions on alternate connections.
INPUT
VIDEO AUDIO
75
E
INPUT
VIDEO AUDIO
75
E
7
C
HAPTER
T
WO
: I
NSTALLATION
I
NSTALLATION
1
1
1
1
2
2
VHF
UHF
INPUT
OUTPUT
VIDEO AUDIO
75
MOVE
VHF
UHF
INPUT
VIDEO AUDIO
75
E
1547278B(MR13-E) 3/27/01 3:42 PM Page 11