Filter
Top Products
E-13
E-14
WHEN ELECTROSTATIC DISCHARGE (ESD) OCCURS AT THE FRONT SURFACE
(WHETHER METAL OR PLASTIC) OR NEAR ANYPART ORANY BUTTON OF THIS
UNIT, ORAT THE USB PORTAND/ OR SD-CARD SLOTS (IF THEY EXIST ON THIS
PRODUCT), THERE MAY BEA POSSIBILITY THAT THE PRODUCT MAY STOP
OPERATION AND/ OR SHUT DOWN IMMEDIATELY. THIS ISA NORMAL CONDITION
AND INTENDED TO PROTECT THE UNITAND INTERNAL COMPONENTS AGAINST
DAMAGE.
IN SUCH ACASE, PLEASE RESET THE UNIT (BY DISCONNECTING AND
RECONNECTING AC-POWER SOURCE) TO REVERT THE UNIT TO NORMAL
OPERATION.
ELECTROSTATIC DISCHARGE (ESD) PRECAUTION
BATTERY SHOULD NOT BE EXPOSED TO EXCESSIVE HEAT SUCH AS SUNSHINE,
FIRE OR THE LIKE.
THE APPARATUS SHOULD NOT BE EXPOSED TO DRIPPING OR SPLASHINGAND
NO OBJECTS FILLED WITH LIQUIDS SHOULD BE PLACED ON THE APPARATUS.
THE MARKING AND RATING LABEL IS LOCATEDAT REAR/ BOTTOM ENCLOSURE
OF THE APPARATUS.
THE MAINS PLUG IS USED AS THE DISCONNECT DEVICEAND IT SHALL REMAIN
READILY OPERABLE. TO BE COMPLETELYDISCONNECTED THE POWER INPUT,
THE MAINS PLUG OF THE APPARATUS SHALL BE DISCONNECTED FROM
THE MAINS COMPLETELY. THE MAINS PLUG SHOULD NOT BE OBSTRUCTED
OR SHOULD BE EASILYACCESSED DURING INTENDED USE.
UNDER THE INFLUENCE OF ELECTROSTATIC PHENOMENON,
THE PRODUCT MAY MALFUNCTIONAND USER TO POWER RESET.
EXCESSIVE SOUND PRESSURE FROM EARPHONES AND HEADPHONES CAN
CAUSE HEARING LOSS.
CAUTION
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY
WITH THE SAME OR EQUIVALENT TYPE.
II) DC JACK - 2
THIS JACK IS DESIGNATED FOR USE WITH THE SUPPLIED UNIVERSALADAPTER WIRE,
IN COMBINATION WITH ONE OF THE SUPPLIED CONNECTORS, TO CHARGE ONE OF
SEVERAL MOBILE PHONES.
LIFT THE UNITTRAY, CONNECT THE TAILEND OF UNIVERSALADAPTER WIRE INTO THE
DC JACK-2,AND CONNECT ONE OF THE SUPPLIEDADAPTER CONNECTORS TO THE
UNIVERSALADAPTER WIRE FEMALE SOCKET.
INSERTTHE ADAPTER CONNECTOR TO THE RESPECTIVE MOBILE PHONE’SADAPTER
SOCKET,WHICH NEEDS TO BE CHARGED.
THE UNIT SHALLTHENAUTOMATICALLY BEGIN CHARGINGTHE RESPECTIVE MOBILE
PHONE.
*NOTE:ATANY GIVEN TIME, ONLYONE OF THE DC-JACKS CAN BE USED.
IN THE EVENTTHAT THE SUPPLIED WIRESAND CONNECTORS ARE UNABLETO CHARGE
YOUR MOBILE PHONE, THIS UNIT IS EQUIPPED WITHA USB (CHARGING ONLY) JACKTO
CHARGE MOBILE PHONES THATARE SUPPLIED WITH USB CABLES.
THE USB JACKALLOWS FOR NOT ONLY CHARGING OF MOBILE PHONES BUTALSO
HUNDREDS OF OTHER DEVICES, COVERING BLUETOOTH HEADSETS, PORTABLEGAME
CONSOLESAND MANY MORE. TO USETHE USB JACK CHARGING CAPABILITY:
LIFT THE UNITTRAY, CONNECT THE TAILEND OF THE USB-WIRE (SUPPLIED WITH YOUR
MOBILE PHONE OR THIRD PARTY DEVICE) INTO THE DC JACK,AND CONNECT THE
DEVICEADAPTER END ON THE USB-WIRE INTO THE RESPECTIVE SOCKETON THE
DEVICE IN NEED OF CHARGING.
THE UNIT SHALLTHENAUTOMATICALLY BEGIN CHARGINGTHE RESPECTIVE DEVICE.
CHARGING 3: USB JACK
2
1
WIRE CONNECTOR
MINI USB
MICRO USB
SAMSUNG
MOTOROLA
SONY ERICSSON
(Male3.5x1.1mm) (Female3.5x1.1mm)
DEVICES CONNECTOR
(Male3.5x1.1mm)
THIS UNIT COMES WITH 5 CONNECTORADAPTERS, TO COVER CHARGING OF MOST
POPULAR MOBILE PHONE MODELSAND BRANDS, DETAILSAS ABOVE DRAWING.
CONNECTOR COMPATIBILITY
(MOST BLACKBERRY
& HTC UNITS)
(SELECT BLACKBERRY
& OTHER UNITS)
SPECIFICATIONS
POWER SUPPLY : ............... DC 6V, 3ATHOUGH BUILT-IN DC JACK
EXTERNALAC-DC POWER ADAPTOR 110V-240V ~ 50/60Hz
SPEAKER : ........................... MAIN SPEAKER 2" x 2
FREQUENCY : ..................... FM 87.5 -108 MHz
USING THE AUDIO LINE IN CONNECTION (AUX-INPUT)
- YOU CAN CONNECTTHE AUDIO OUTPUT OF AN EXTERNALDEVICE SUCH ASA MP3
PLAYER TOTHIS UNIT, TO LISTEN TO THE SOUND OF THAT DEVICETHROUGH THE
HIGH QUALITYAMPLIFIER OF THIS MUSIC SYSTEM.
- TO CONNECTTHE EXTERNAL DEVICE PLEASE USEA STANDARD STEREO
HEADPHONE (3.5MM TO 3.5MM PLUGS) CABLE TO CONNECT THE
"HEADPHONE-OUT ORAUDIO LINE-OUT" OF THE DEVICE TO THEAUX-INPUT SOCKET
OF THIS UNIT.
- SWITCH THE FUNCTION TO "AUX" USING THE FUNCTION KEY ON UNIT OR AUX KEY
ON REMOTE CONTROL.
- SWITCH ON THE UNITAND THE EXTERNAL DEVICE (eg. MP3-PLAYER).
- START PLAYBACK OF THE EXTERNAL DEVICEAND ADJUSTTHE VOLUME CONTROL
OF THE MAIN UNIT TO THE DESIRED LEVEL.
- REMEMBER TO SWITCH OFF THE UNIT WHEN YOUARE FINISHED USING THE
EXTERNAL DEVICE.