Filter
Top Products
OR BACK/ TUNE -NEXT/ TUNE +
E-8
E-7
SWITCH UNIT TO "STAND-BY" MODE
PRESS & HOLD FOR 3 SECONDS
DISPLAY SHOWS HOUR OR HOUR (FLASHING)
CLOCKADJ.
12
24
PRESS TO SELECT 12-HOUR
OR 24-HOUR CLOCK DISPLAY SYSTEM & PRESS TO CONFIRM
YOUR SELECTION
CLOCKADJ.
PRESS REPEATEDLY TO SET
THE CORRECT IN THE DISPLAY & PRESS TO CONFIRMHOUR
CLOCKADJ.
PRESS REPEATEDLY TO SET
THE CORRECT IN THE DISPLAY & PRESS TO CONFIRMMINUTE
CLOCKADJ.
CORRECT TIME IS NOW SET & WILLBE SHOWN IN THE DISPLAY!
DIGITAL CLOCK FUNCTION
HOW TO SET CORRECT TIME:
THIS UNIT HASA BUILT-IN DIGITALCLOCK, WHICH IS DISPLAYED ATALL TIMES DURING
THE UNIT BEING POWERED, OTHER THAN DURINGTHE FOLLOWING THREE SITUATIONS:
1) WHEN THE DIMMER FUNCTION IS ENABLED TO HAVE DISPLAY BRIGHTNESS LEVELAT
0 (DISPLAY LIGHTS OFF/ FULLDIMMED).
2) WHEN USING THE FUNCTION KEYTO SELECT THE RADIO FM MODE, THE DISPLAYWILL
MOMENTARILY SHOW
THE FM FREQUENCY PAY BACK BEFORE RETURNINGTO THE DIGITAL CLOCK.
3) WHEN USING THE NIT FUNCTIONS/ CONTROLS (I.E. VOLUME CONTROL, FM
FREQUENCY TUNING,ALARM SETTING
ETC.), THAT REQUIRE INFORMATIONTO BE MOMENTARILY DISPLAYED.
TO SETTHE TIME, FOLLOW THE BELOW STEPS:
*NOTE:
THAT WHEN THE DIGITALCLOCK IS NOT SET,THE DIGITAL CLOCK DISPLAY SHALL
CONTINUOUSLY FLASH TO INDICATE THAT THE CORRECTTIME HAS NOT YET BEEN SET.
ALARM FUNCTION
ALARM TIME SETTING
- THIS SETIS EQUIPPED WITH 3ALARM MODES: BUZZER, RADIOAND iPod.
BEFORE SETTINGTHE ALARM, MAKE SURETO SETTHE CLOCK.
1.AT STANDBY MODE, PRESSAND HOLD ALARM SET KEYUNTIL THE DISPLAY
HOUR FLASHING.
2. PRESS KEYTO REACH THE HOUR OF
THE DESIRED WAKE UPTIME.
3. PRESS TO CONFIRMTHE UNIT SHOULD NOW HAVE THE DISPLAY
MINUTES FLASHING.
4. PRESS
ALARM SET
KEY TO REACHTHE MINUTES OF
THE DESIRED WAKE UPTIME.
5. PRESS ALARM SET KEYTO COMPLETEAND CONFIRM THE ALARMTIME SETTING.
ALARM ON SETTING
ONCE THEALARM TIME IS SET, SELECTTHE SOURCE THATYOU WISH THE UNIT
TO PLAYBACK FROMATWAKE UPTIME:
AL =BUZZER ALARM / FM =RADIO / iPod =iPod or iPhone
1.AT STANDBY MODE, PRESS ALARM SET KEYONCE, THE DISPLAY
WILL CHANGEFROM REAL TIMETOALARM WAKE UPTIME THAT WAS SET.
2. PRESS ALARM SET KEY REPEATEDLYTO SELECTTHE SOURCEAS DESIRED,
THE SELECTED SOURCE WILLBE INDICATED BYTHE SYMBOLFLASHING,
AFTER SELECTINGTHE SOURCE, THE SETWILL RETURNTO STANDBY MODE
AFTERABOUT 5 SECONDS THE AL SYMBOL WILLBE SHOWN ONTHE DISPLAY
AS LONGAS THEALARM FUNCTION IS "ACTIVE".
ALARM OFF SETTING
1.AT STANDBY MODE, PRESS ALARM SET KEY ONCE, THE DISPLAY WILLCHANGE
FROM REALTIME TOALARM WAKE UPTIME THATWAS SET.
2. PRESS ALARM SET KEY REPEATEDLYTO SELECTTHE AL SYMBOL,
UNTILTHE AL SYMBOL STOP FLASHINGTO INDICATE "ALARM OFF",
THE SETWILL RETURN TO STANDBYMODE AFTERABOUT 5 SECONDS,
THE AL SYMBOL WILLDISAPPEAR FROMTHE DISPLAY.
ALARM MODE SETTING
1. FOR iPod/ iPhone:CONNECT THE iPod/ iPhoneAS DESCRIBED. SELECT &PAUSE
PLAYBACK OFTHE SONG OR DESIRED PLAYLISTTO PLAY AT THE WAKE UPTIME.
(PLAYBACK WILLAUTOMATICALLY RESUMEATALARM TIME).
2. FOR RADIO:TUNE IN THE DESIRED STATION, PRIOR TO PLAYING THE UNIT ON
STANDBY MODE.
3. THE WAKE UPVOLUME LEVELAUTOMATICALLY WILLRISE FROM
LEVEL 0- 16 (MINIMUM) FOR WAKE UPVOLUME LEVEL MORETHAN 16
IT MUSTBE SET BYTHE USER.
4. IFTHE ALARM IS SETAS WAKE TO iPod. YOU WILLNEED TO CONNECTTHE iPod
PROPERLYAS DESCRIBED. OTHERWISE, THE BUZZERALARM WILLSOUND
AT THESET TIME IFTHE iPod HAS NOTBE CONNECTED.
5. THEALARM WAKE UPTIMER WILLAUTOMATICALLY TURN OFFAFTER
AROUNDAN HOUR.
OR BACK/ TUNE -NEXT/ TUNE +
OR BACK/ TUNE -NEXT/ TUNE +
OR BACK/ TUNE -NEXT/ TUNE +
OR BACK/ TUNE -NEXT/ TUNE +