Filter
Top Products
Additional information
13
78
En
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.
• If the system does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
General
Problem
Remedy
The power does not
turn on.
• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear
panel. This could cause the system to shut off automatically.
No sound is output
when a function is
selected.
• If you’re using the line input, make sure the component is connected
correctly (see
Connecting auxiliary components
on page 68).
• Press
MUTE
on the remote control to turn muting off.
• Adjust the
VOLUME
.
•
European model only:
If you’re using the TV input, make sure you’ve
selected the RCA audio input (see
Switching the TV audio input from SCART
to RCA
on page 71).
No image is output
when playing discs.
• Make sure the TV is connected correctly (refer to the Setup Guide).
•
Not applicable to the European model:
Reset the video output to
interlace (see
Component Out
on page 61).
No sound from
surround or center
speakers.
• Refer to
Setting the channel levels
on page 57 to check the speaker levels.
• Check that you haven’t selected the
STEREO
sound mode (see
Listening
in surround sound
on page 29).
• Check that the Virtual mode is not on (
Using the Advanced Surround
effects
on page 31).
• Connect the speakers properly (refer to the Setup Guide).
Can’t operate the
remote control.
• Replace the batteries (refer to the Setup Guide).
• Operate within 7 m, 30° of the remote sensor on the front panel (refer to
the Setup Guide).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
HTS.book 78 ページ ２００３年２月２５日 火曜日 午後１時４５分