Filter
Top Products
20
English
AZ 5140/98 page 20
MAINTENANCE
• Place the set on a hard, flat surface so that the system does not tilt.
• Always shut the CD door to keep the CD compartment dust-free. To
clean the dusted compartment with a soft dry cloth.
• The mechanical parts of the set contain self-lubricating bearings and
must not be oiled or lubricated.
•To clean the set, use a soft, slightly dampened chamois leather. Do not
use any cleaning agents containing alcohol, ammonia, benzene or
abrasives as these may harm the housing.
•
Do not expose the system, batteries or discs to humidity, rain,
sand or excessive heat (caused by heating equipment or direct
sunlight). Always keep the disc tray closed to avoid dust on the
lens.
•
No objects filled with liquids, such as vases, shall be placed on
the apparatus.
• The apparatus shall not be exposed to dripping or splashing.
• Adequate ventilation with a minimum gap of 15 cm between the ventilation holes and surrounding
surfaces is necessary to prevent heat build-up.
• The ventilation should not be impeded by covering the ventilation openings with items, such as
newspapers, table-cloths, curtains, etc.
• No naked flame sources, such as lighted candles, should be placed on the apparatus.
• The lens of the CD player should never be touched.
• Sudden changes in the surrounding temperature can cause
condensation to form and the lens of your CD player to cloud over.
Playing a CD is then not possible. Do not attempt to clean the lens but
leave the set in a warm environment until the moisture evaporates.
• Use only Digital Audio CDs.
•To take a CD out of its box, press the centre spindle while lifting the
CD. Always pick up the CD by the edge and replace the CD back in its
box after use to avoid scratching and dust.
•To clean the CD, wipe in a straight line from the centre towards the
edge using a soft, lint-free cloth. Do not use cleaning agents as they
may damage the disc.
• Never write on a CD or attach stickers to it.
CD PLAYER AND CD HANDLING
PRECAUTIONS & GENERAL MAINTENANCE
X
P001-021_AZ5140_98-Eng 3/11/05 9:50 Page 20