Filter
Top Products
10
English
AZ 5140/98 page 10
GENERAL OPERATION
1. Check if the mains voltage as shown on the type plate (on
the bottom of the set) corresponds to your local mains
voltage. If it does not, consult your dealer or service
organization.
2. Connect the mains lead to the AC MAINS
~ socket and the
wall socket.
™ The set is now ready for use.
3. To switch off the mains supply completely, pull the mains plug out of the wall socket.
™ Disconnect the mains lead when you change over to battery supply, or to protect the set
during heavy thunderstorms.
The type plate is located on the bottom of the set.
1. To switch on the set, adjust the source selector.
2. Adjust the sound using the VOLUME and DBB controls.
3 To switch off the set, adjust the source selector to the
TAPE/OFF position, with the cassette keys released.
1 Set the source selector to FM or MW.
2. Adjust the sound using the VOLUME controls and the DBB
switch.
3. Tune to a radio station using the TUNING knob.
– For FM, pull out the telescopic aerial. To improve FM-reception,
incline and turn the aerial. Reduce its length if the FM-signal is
too strong (very close to a transmitter).
– For MW, the set is provided with a built-in aerial, so the
telescopic aerial is not needed. Direct the aerial by turning
the whole set.
4. To switch off, set the source selector to the TAPE/OFF
position (with the cassette keys released).
RADIO RECEPTION
GENERAL OPERATION
MAINS
P001-021_AZ5140_98-Eng 3/11/05 9:50 Page 10