Filter
Top Products
POWER
MARKER
SEARCH MODE
DISPLAY SLOWZOOM
OUTPUT SELECT
3
4
5
6
7
8
9
SPEED
TIMER SET
0
+
10
2
1
VCR
DVD
CLEAR
REPEAT
SETUP
TITLE
RETURN
MODE
CHANNEL/SKIP
A-B
AUDIO
ANGLESUBTITLE
REC/OTR
REPEAT
DISC
MENU
OK
PAUSE
REW FF
PLAYSTOP
VCR/TV
MEMORY
STATUS/EXITTIME SEARCH
3
Within 60 seconds, press PLAY B (o) or STOP C
(p) to select English or Spanish as the language for
VCR on-screen displays and menus.
4
Press DISC/MENU.
SELECT op
→ENGLISH ON
ESPAÑOL
MAKE SELECTION OR
PUSH MENU TO CONTINUE
First-time DVD/VCR Setup 15
5
Within 60 seconds, press CHANNEL/SKIP G (o)
to begin automatic channel programming. AUTO
CH PROGRAMMING IN PROCESS PLEASE WAIT will
appear on the TV screen. The DVD/VCR will memorize all
available channels. When all channels are memorized,
CHANNELS ARE SET will appear on the screen briefly,
then TV programming will appear.
These channels will be available when you want to watch
TV while in VCR mode. To put the DVD/VCR in VCR
mode, press OUTPUT SELECT so the green VIDEO light
appears. Then press VCR/TV so the VCR/TV light appears.
Press the VCR button, then use CHANNEL/SKIP
j/i (p/o) and the Number buttons to select a TV
channel for viewing.
• To skip this feature and play a tape
immediately, insert a tape with its
record tab removed.
• To skip step 3, press DISC/MENU.
All on-screen displays will be in
English. To skip step 5, press STOP
C (p). Channels will not be pro-
grammed, and CHANNELS NOT
SET will appear on the screen.
• If you try to program channels
when there is no antenna or Cable
TV signal connected to the ANT-IN
jack of the DVD/VCR, programming
will appear to take place, but even-
tually a NO TV SIGNALS message
will appear. Connect an antenna or
Cable TV signal to the DVD/VCR’s
ANT-IN (Antenna In) jack and press
CHANNEL/SKIP G (o) again. If
channel programming does not
resume, follow the steps on page 24.
• You may need to repeat the steps
on this page if the power fails.
Helpful Hints
Before turning on your DVD/VCR, make sure batteries are in the
remote control and the DVD/VCR and TV are connected correctly.
● You cannot program channels if you are using a Cable Box or a
Direct Broadcast System.
1
Press VCR, then press POWER
yy
. “P-ON” will
appear briefly on the front of the DVD/VCR. The green
VIDEO light, the VCR/TV light, and the Power light will
appear on the front of the DVD/VCR.
2
Turn on the TV. Set it to the same channel as the
CH3/CH4 switch on the back of the DVD/VCR. The
display shown below will appear. (If the display does not
appear, check your hookups, then follow the steps on page
24 to set up channels and page 29 to select a language.)
2
Turn on the TV.
1
3
4
5
CONNECTANTENNA ORCABLE
TOVCR
THEN...
PUSHCHUPKEY
OR...
FOR PLAY ONLY - PUSH STOP
DVD740VR 4/12/02 12:08 PM Page 15