Filter
Top Products
10
Note
If you are not going to use the remote control
for a long time, remove the batteries.
Do not use old and new or different types of
batteries in combination.
Batteries contain chemical substances, so they
should be disposed of properly.
Auto install radio stations
When you connect the unit to the power
VXSSO\IRUWKHÀUVWWLPHRUQRUDGLRVWDWLRQLV
stored in this unit, Plug and Play is activated to
store all available radio stations automatically.
1 Connect the unit to the power supply.
[AUTO INSTALL - PLEASE PRESS »
PLAY, STOP CANCEL] (auto install
- press
; to cancel, press ) is
displayed.
2 Press on the main unit to start
installation.
[AUTO] (auto) is displayed.»
The unit automatically stores radio »
VWDWLRQVZLWKVXIÀFLHQWVLJQDOVWUHQJWK
When all the available radio stations »
DUHVWRUHGWKHÀUVWSUHVHWUDGLRVWDWLRQ
is broadcast automatically.
4 Get started
Caution
Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
rear of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from
KHDWVXQVKLQHRUÀUH1HYHUGLVFDUGEDWWHULHV
LQÀUH
1 Open the battery compartment.
2 Insert 2 AAA batteries (not supplied)
with correct polarity (+/-) as indicated.
3 Close the battery compartment.
EN