Filter
Top Products
Safety information
• Place the set on a hard, flat and stable surface
so that the system does not tilt.
• Where the MAINS plug or an appliance cou-
pler is used as the disconnect device, the dis-
connet device shall remain readily operable.
• Do not expose the set, batteries, CDs to
humidity, rain, sand or excessive heat caused
by heating equipment or direct sunlight.
• The apparatus shall not be exposed to
dripping or splashing.
• Adequate ventilation with a minimum gap of
15 cm between the ventilation holes and sur-
rounding surfaces is necessary to prevent
heat build-up.
• The ventilation should not be impeded by
covering the ventilation openings with items,
such as newspapers,table-cloths, curtains, etc..
• No objects filled with liquids, such as vases,
shall be placed on the apparatus.
• No naked flame sources, such as lighted can-
dles, should be placed on the apparatus.
• The mechanical parts of the set contain
self-lubricating bearings and must not be oiled
or lubricated.
•To clean the set, use a dry cloth. Do not use
any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may
harm the housing.
CD player and CD handling
• If the CD player cannot read CDs correctly,
use a cleaning CD to clean the lens before
taking the set to repair.
• The lens of the CD player should never be
touched!
• Sudden changes in the surrounding
temperature can cause condensation on the
lens of your CD player. Playing a CD is then
not possible. Do not attempt to clean the
lens but leave the set in a warm environment
until the moisture evaporates.
•Always close the CD door to avoid dust on
the lens.
•To clean the CD, wipe in a straight line from
the center towards the edge using a soft,
lint-free cloth. Do not use cleaning agents as
they may damage the disc.
• Never write on a CD or attach any stickers
to it.
Cassette recorder
•
To ensure a good recording and playback
of the tape deck, clean parts A,B and C
shown in the diagram below, after approx.
50 hours of operation, or on average once
a month. Use a cotton bud slightly mois-
tened with alcohol or a special head clean-
ing fluid to clean the deck.
•
Open the cassette holder by pressing
9/
.
•
Press 1 and clean the rubber pressure
rollers C.
•
Press ;and clean the magnetic heads A
and also the capstans B.
•
After cleaning, press
9/
.
•
Cleaning of the heads can also be done by
playing a cleaning
cassette through once.
Safety & Maintenance
(See 0)
Environmental information
All unnecessary packaging material has
been omitted.The packaging can be easily
separated into three materials: cardboard,
polystyrene and plastic.
Your set consists of materials
which can be recycled if disassem-
bled by a specialized company.
Please observe the local regula-
tions regarding the disposal of
packaging, dead batteries and old
equipment.
AZ1856_Eng_93_CCR 2008.3.12 13:26 Page 14