Filter
Top Products
Setup-Clock Display/Memory Status Clock/Alarm
Setup-Clock Display
You can set whether to display clock or not
in photo mode.
1 Press CLOCK.
2 Press SETUP.
3 Press UP or DOWN repeatedly to
highlight Clock Display.
4 Press SELECT.
5 Press UP or DOWN to select ON or
OFF.
6 Press SELECT to save setting and exit.
Viewing Memory Status
You can check the occupied memory and
how much capacity is left.
1 Press CLOCK.
2 Press SETUP.
3 Press DOWN repeatedly to highlight
Memory Status.
The memory occupation status of photo
and voice memo is displayed respectively.
4 Press UP to enter other settings.
5 Press BACK to exit setting.
Helpful hints:
During setting the set, if no button is pressed
within 10 seconds, the set returns to SETUP
mode automatically.
➜
–
Displaying clock
1 Press CLOCK.
To activate or deactivate
alarm
1 Press ALARM repeatedly.
is displayed when alarm is activated.
disappears when alarm is deactivated.
Repeating alarm
You can repeat the alarm call at 9-minute
intervals.
During the alarm call, press REPEAT
ALARM / BRIGHTNESS CONTROL.
fl ashes.
Helpful hints:
During alarm call, if no button is pressed, alarm
call will last 30 minutes.
Note:
For instructions on setting the clock and alarm,
please refer to chapter Setup - Clock and
Setup - Alarm.
➜
➜
➜
–
–
AJL305_05_CCR.indd 9AJL305_05_CCR.indd 9 2008-01-24 2:04:36 PM2008-01-24 2:04:36 PM