Filter
Top Products
Important notes for users in the U.K.
Mains plug
This apparatus is fi tted with an approved 13 Amp plug.To change a fuse in
this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI approved
type.
3. Refi t the fuse cover.
If the fi tted plug is not suitable for your socket outlets, it should be cut off
and an appropriate plug fi tted in its place. If the mains plug contains a fuse,
this should have a value of 3 Amp. If a plug without a fuse is used, the fuse at
the distribution board should not be greater than 3 Amp.
Note: The severed plug must be disposed of to avoid a possible shock
hazard should it be inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the following code: blue =
neutral (N), brown = live (L). As these colours may not correspond with the
colour markings identifying the terminals in your plug, proceed as follows:
• Connect the blue wire to the terminal marked N or coloured black.
• Connect the brown wire to the terminal marked L or coloured red.
• Do not connect either wire to the earth terminal in the plug, marked E
(or e) or coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is clamped
over the sheath of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require consent. See Copyright Act
1956 and The Performer’s Protection Acts 1958 to 1972.
AJL305_05_CCR.indd 3AJL305_05_CCR.indd 3 2008-01-24 2:04:33 PM2008-01-24 2:04:33 PM