Philips AJ 3600 Clock Radio User Manual


 
Manual tuning
•Press TUNING +/- briefly or repeatedly until you reach the desired frequency.
To improve reception:
For FM, extend and position the pigtail fully to obtain optimum reception.
For MW, the set is provided with a built-in aerial. Direct the aerial by adjusting the
position of your clock radio.
STORING AND USING PRESET STATIONS
You can store up to a total of 10 radio stations in the memory, 5 on each wave-
band.
1 Tune to your desired station (see TUNING TO RADIO STATIONS).
2 To store a preset, hold down briefly on a PRESET button 1-5 until you hear a double
beep.
Display shows the preset number of your station.
3 Repeat steps 1 and 2 to store your other stations.
You can overwrite a preset station by storing another frequency in its place.
4
Press a.
PRESET button 1-5 to listen to a preset station.
USING THE ALARM
GENERAL
Two different alarm times can be set. This can be useful when you need to be
woken up at a different time e.g. during the week and at the weekend:
ALARM 1 - radio mode
ALARM 2 - buzzer mode. The gentle wake buzzer alarm increases its beep tone fre-
quency within seconds.
SETTING THE ALARM TIME AND MODE
(See 5)
1. Check the radio is switched off.
2. Press AL 1 or AL2 to on.
Display: ON
appears under the respective
AL
or
AL
icon.
3. Press and
hold SET ALARM 1 or SET ALARM 2 until alarm time digits flash.
4.
Hold down or press HOUR + or MINUTE + repeatedly to set and adjust the
hours and minutes respectively. Release HOUR + or MINUTE + when you
have reached the correct setting.