Filter
Top Products
24
RQT6279
REW
7
1
7
3
7
2
TAPE ⁄ CD
7
A
DISPLAY
C RESET
SLEEP TIMER FADER DISPLAY
23
PGM/-CLEAR
1
56≥104
8907
C RESET RANDOM REPEATFM MODE/BP
PRESET EQ
S VIRTUALIZER
TAPE TUNER CD
REW FF
7
1
7
2
7
3
VOLUME
Insert the cassette with the exposed tape facing you.
!"#$%&'()
Side to be played back facing up
!"#$%&
DECK
Cassettes
■
1
Press [0 DECK] to open the deck.
(The unit comes on.)
Load a cassette and close the deck by hand.
■
2
Press [ : TAPE] to start play.
■
3
Press [+, – VOLUME] to adjust the volume.
To stop play
Press [L TAPE/CD].
One touch play (When using AC power)
When a cassette is loaded, press [:
TAPE].
The unit comes on and play starts.
Fast-forward and rewind
Press [REW / – / Q ] (rewind) or [R / + / FF] (fast-forward).
On the remote control
Press [REW / –] (rewind) or [+ / FF] (fast-forward).
Selection of tapes
Use normal position tapes to play correctly.
High position and metal position tapes can be played, but the unit will
not be able to do full justice to the characteristics of these tapes.
Cassette tape care
• Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
• Tape slack can get caught up in the mechanism and should be
taken up before the tape is played.
• Endless tapes can get caught up in the deck’s moving parts if used
incorrectly.
Tips on Recording
Use household AC power or new batteries when recording to avoid
poor recordings caused by the batteries running down.
Televisions can cause interference to recordings made on this unit if
the two are too close to each other.
Selection of tapes for recording
Use normal position tapes.
High position and metal position tapes can be used, but the unit will
not be able to record or erase them correctly.
Volume and sound quality in recording
• Recording level is set automatically.
• Recording are unaffected by changes to sound quality.
To display the tape counter while recording
Remote control only
Press [DISPLAY].
Each time you press the button in the CD or radio mode:
a
Present state
b
Present time
c
Tape counter
To reset the tape counter
Press [C-RESET].
The counter resets to “000”.
A
Æpà tł«uÄ ·uAJ*« j¹dAë V½Uł ÊuJ¹ YO×Ð XOÝUJë qšœ√
vKŽ√ vÃ≈ tOÃ≈ ŸUL²Ýù« …œUŽ≈ œ«d*« V½U'«
RQT6279-G (24-29)3 7/12/01, 4:48 PM24